Stid SPECTRE Notice D'installation page 7

SPECTRE Access UHF
Read only & OSDP™
Installation procedure
Mount with 75 x 75 mm / 0.79 x 0.79 in Standard VESA mounting
bracket (M4x12 stainless steel screws provided with mounting
kit)
Horizontal polarization F = 867 MHz
STid declares that the SMA-R5x/R4x-A reader is compliant to the fundamental requirements of Directive RED 2014/53/EU and Directive RoHs 2011/65/EU and
Commission Delegated Directive 2015/863/EU. A copy of our declaration is available upon request send to qualite@stid.com.
This device complies with Part 15 of the FCC rules and with Innovation, Science and Economic Development Canada's license-exempt RSS(s). Operation is subject
to the following two conditions:
1) This device must not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can emit radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for assistance.
This equipment complies with FCC's and ISEDC's radiation exposure limits (using RSS-102 rules) set forth for an uncontrolled environment under the following
conditions:
This equipment should be installed and operated such that a minimum separation distance of 34 cm / 13.39 in is maintained between the radiator
-
(antenna) and the user's/nearby person's body at all times.
The transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
-
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1127X07 - Page 6 sur 18 - Ed. 28/05/2021
UHF SPECTRE Access
Lecture seule & OSDP™
Notice d'installation
Antenna Mounting
Two mounting possibilities:
Adjustable wall-mounted kit
(refer to the Installation Procedures
for KFX-UHF-08)
Wall
Azimuth pattern
Horizontal polarization F = 915 MHz
Declaration of Compliance
UHF SPECTRE Access
Solo lectura & OSDP™
Manual de instalación
Adjustable ole-mounted kit
(refer to the Installation Procedures
for KFX-UHF-09)
Vertical polarization F = 867 MHz
US
FR
ES
Pole
Vertical polarization F = 915 MHz