Stid SPECTRE Notice D'installation page 3

SPECTRE Access UHF
Read only & OSDP™
Installation procedure
In order to access the module/reader connectors, open
the hatch.
Cable glands (Data Bus-Power sup. - Input/Output)
J6
J9
J7
J14
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1127X07 - Page 2 sur 18 - Ed. 28/05/2021
UHF SPECTRE Access
Lecture seule & OSDP™
Notice d'installation
only the hatch provided for this purpose by unscrewing the 4 captive screws without removing them from
Green LED
Red LED
TTL / RS232 / RS485 / I/O Connection - SMA / SLA
Use this (on RS485 connection) when the distance of the data cable is near or over
100 m / 328.08 ft and the signal is weakened (polluted signals, frame errors etc.).
Micro USB connector for configuration purposes only
Use this connector for earth connection purpose
IN 1-2-3-4
OUT 1-2-3-4
V- opt Low polarization potential of opto-coupled inputs and outputs
V+ opt High polarization potential of opto-coupled inputs and outputs
DATA1
CLK1
DATA 2 / CLK2
DATA 3 / CLK3
DATA 4 / CLK4
ALIM
GND
Host Connection Access - SMA / SLA
Front View of the Module - SMA / SLA
RF port 1 RF port 2
End of line resistor RS485
TTL output level: +5V or Vin
4 opto-coupled inputs
4 opto-coupled outputs
Data or D0 Channel 1 or Tx (RS232) or L+ (RS485)
Clock or D1 Channel 1 or Rx (RS232) or L- (RS485)
Data/Clock or D0/D1 Channel 2
Data/Clock or D0/D1 Channel 3
Data/Clock or D0/D1 Channel 4
Power supply
GND
UHF SPECTRE Access
Solo lectura & OSDP™
Manual de instalación
RF port 3 RF port 4
US
FR
ES