Filter Replacement - Husqvarna DE 110S Manuel D'utilisation

CAUTION:
across the filter surface as this will do
damage to the filter.
4. Let the prefilter dry fully.
CAUTION:
100% dry before you install it into the
housing.
5. Install the prefilter, close the prefilter cover and
tighten the cover locks.
If the prefilter cannot be fully cleaned or if it is damaged,
it must be replaced. Refer to
page 21 .

Filter replacement

WARNING:
personal protective equipment. Refer to
Personal protective equipment on page 12 .
Dangerous dust can release into the air
during filter replacement.
WARNING:
product and disconnect the power supply
before filter replacement.
To replace the prefilter
1. Remove the prefilter. Refer to
with water on page 20 .
2. Put the prefilter carefully in a plastic bag.
3. Discard the plastic bag correctly. Refer to local
regulations.
4. Install the new prefilter.
If the suction is not sufficient when a new prefilter is
installed, it is necessary to replace the HEPA filter. Refer
To replace the HEPA filter on page 21 .
to
To replace the HEPA filter
The HEPA filter cannot be cleaned. It is always
necessary to replace it with a new HEPA filter. Only use
Husqvarna AB HEPA filters.
1587 - 007 - 24.01.2022
Do not hit or drag items
The prefilter must be
To replace the prefilter on
Use
Stop the
To clean the prefilter
WARNING:
approved service center or an approved
authority is permitted to replace the HEPA
filter.
WARNING:
personal protective equipment, refer to
Personal protective equipment on page 12 .
WARNING:
particles in the HEPA filter are dangerous to
your health.
WARNING:
that there are no holes in the HEPA filter. A
damaged HEPA filter is a health risk.
WARNING:
filter. If you install a used HEPA filter,
leakage and decreased filtration efficiency
can occur.
CAUTION:
surface of the HEPA filter. This can cause
damage to the HEPA filter.
1. Loosen the 6 screws and remove the HEPA filter
cover. (Fig. 31)
2. Attach the dust cap (A) and pull out the HEPA filter.
Put it into a clean plastic bag (C). (Fig. 32)
3. Discard the plastic bag correctly. Refer to local
regulations.
4. Install a new HEPA filter. Make sure that the HEPA
filter is pushed to the end position. (Fig. 33)
5. Install the HEPA filter cover and tighten the 6
screws.
Only an
Always use
The
Make sure
Do not install a used HEPA
Do not touch the inner
21