Maintenance; Maintenance Schedule - Husqvarna DE 110S Manuel D'utilisation

2. Stop the product, refer to
on page 16 or To start and stop DE 110/DE 120 on
page 17 .
3. Discard the Longopac bag. Refer to
Longopac bag and prepare a new Longopac bag on
page 17 .
Introduction
WARNING:
related accidents occur during the
troubleshooting, servicing and maintenance
as the operator must be in the risk area of
the product. The operator must be careful,
make a plan and prepare the work to
prevent accidents.
WARNING:
do maintenance, make sure that the motor
switch and the pump switch are in the Off
positions. Disconnect the power cord and
remove the pump cable.
WARNING:
approved electrician do all checks of the
electric components.

Maintenance

Do the filter purge procedure. Refer to
# .
Look for signs of wear or damage of the
dust release rubber cone.
Do a check of the power plug and the
power cord.
Look for signs of wear, damage or loose
connections of the controls before the
unit is connected.
Do a check of the hose and the hose
connectors.
Look for signs of wear or damage of the
plastic parts.
Do a check of the lifting eyes.
18
To start and stop DE 110S
To discard a full
Maintenance
Product
Before you
Only let an
Before
each use
X
X
X
X
X
X
X
4. Clean the product. Refer to
page 20 .
5. Prepare the product for transportation. Refer to
move the product long distances on page 24 .
WARNING:
that you do not make a hole in the filter. Risk
of dust dispersion.
WARNING:
that you obey all local regulations to dispose
the dangerous dust correctly, before and
during maintenance.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
Daily Weekly suction is
To clean the product on
Make sure
Make sure
When Each 6
months or months or
low 600 h
1587 - 007 - 24.01.2022
To
Each 12
2000 h