Cleaning The Glass Cooktop; Control Knobs; Normal Daily Use Cleaning; Heavy, Burned-On Residue - GE Appliances JP3021 Manuel D'utilisation Et Instructions D'installation

Cleaning the Glass Cooktop

Control Knobs

The control knobs may be removed for easier cleaning.
Make sure the knobs are in the Off positions and pull
them straight off the stems for cleaning.
The knobs can be washed with soap and water. Do not
remove chrome accent skirt (on some models). Make
sure the insides of the knobs are dry before replacing.

Normal Daily Use Cleaning

ONLY use ceramic cooktop cleaner on the glass
cooktop. Other creams may not be as effective.
To maintain and protect the surface of your glass cooktop,
follow these steps:
1. Before using the cooktop for the first time, clean it
with ceramic cooktop cleaner. This helps protect the
top and makes cleanup easier.
2. Regular use of a ceramic cooktop cleaner will help
keep the cooktop looking new.
3. Shake the cleaning cream well. Apply a few drops of
ceramic cooktop cleaner directly to the cooktop.
Burned-On Residue
NOTE: DAMAGE to your glass surface may occur if you
use scrub pads other than those recommended.
1. Allow the cooktop to cool.
2. Spread a few drops of ceramic cooktop cleaner on
the entire burned residue area.
3. Using the included non-scratch cleaning pad for
ceramic cooktops, rub the residue area, applying
pressure as needed.
4. If any residue remains, repeat the steps listed above
as needed.

Heavy, Burned-On Residue

1. Allow the cooktop to cool.
2. Use a single-edge razor blade scraper at approximately
a 45° angle against the glass surface and scrape the
soil. It will be necessary to apply pressure to the razor
scraper in order to remove the residue.
3. After scraping with the razor scraper, spread a few drops
of ceramic cooktop cleaner on the entire burned residue
area. Use the cleaning pad to remove any remaining
residue.
4. For additional protection, after all residue has been
removed, polish the entire surface with ceramic
cooktop cleaner and a paper towel.
10
Replace the knobs in the
Off position to ensure
proper placement.
4. Use a paper towel or non-scratch cleaning pad for
ceramic cooktops to clean the entire cooktop surface.
5. Use a dry cloth or paper towel to remove all cleaning
residue. No need to rinse.
NOTE: It is very important
that you DO NOT heat the
cooktop until it has been
cleaned thoroughly.
5. For additional protection, after all residue has been
removed, polish the entire surface with ceramic
cooktop cleaner and a paper towel.
Use a non-scratch cleaning pad for
ceramic cooktops.
The ceramic cooktop scraper and all recommended supplies
are available through our Parts Center. See instructions under
"Assistance / Accessories" section.
NOTE: Do not use a dull or nicked blade.
Ceramic
Cooktop
Cleaner
Clean your cooktop after each spill.
Use ceramic cooktop cleaner.
49-2000738 Rev. 3