Fitting The Bar And Chain - EMAK efco MT 2200 Mode D'emploi

themselves thoroughly with the operation
of the machine before working in the field.
2. The electric saw must only be used by
adults, and users must be in good physical
shape and familiar with the operating
instructions.
3. Assemble the cutting equipment (bar and
chain) before fitting the battery.
4. Never start the electric saw without the
chain-guard on.
5. Do not use faulty batteries. Use only
genuine original batteries.
6. Never cut in the vicinity of other electrical
cables.
7. Always cut from a firm-footed and safe
position. Only start cutting when the chain
is moving. During work use the teeth as a
support point.
8. Ensure that trees fall in a safe direction.
9. It is prohibited to fit any device other than
that supplied by the manufacturer.
10. All labels with health hazards must be kept
in good conditions. In case of damage or
deterioration, immediately substitute them
(see Fig. 1).
11. Never carry out operations or repairs on
your own that are other than routine
m a i n t e n a n c e. C a l l s p e c i a l i s e d a n d
authorised workshops only.
12. A l w a y s f o l l o w t h e m a n u f a c t u r e r 's
i n s t r u c t i o n s f o r t h e m a i n t e n a n c e
operations.
13. Check the saw daily to ensure that all safety
and other devices are working properly.
14. Never work with a saw that is damaged,
poorly repaired, or randomly modified. Do
not remove, damage, or make ineffective
any of the safety devices. Only use bars of
the length indicated in the table (Pag. 33).
15. Only loan your saw to expert users who are
completely familiar with saw operation and
correct use. Give other users the manual
with operating instructions, which they
should read before using the saw.
16. All electric saw service, other than the
operations shown in the present manual,
should be per formed by competent
personnel.
17. Keep this manual on hand and consult it
before each use of the tool.
18. Please note that the owner or the user is
responsible for any accidents or damage to
third parties or their property.
SAFETY PROTECTIVE CLOTHING
Major cases of electric chainsaw accidents
happen when the chain hits the operator.
While working with the electric chainsaw,
always use safety protective approved
clothing. The use of protective clothing does
not eliminate injury risks, but it reduces the
injury effects in case of accident. Consult
your trusted supplier to choose an adequate
equipment.
The clothing must be proper and not an
obstacle. Wear adherent anti-cut clothing.
Anti-cut jackets, dungarees and leggings are
the ideal. Do not wear clothes, scarves, ties or
bracelets that can stuck into woods or twigs.
Tie up and protect long hair (example with
foulards, cap, helmets, etc.)
Safety shoes or boots having skid-proof sole
and anti-piercing insert.
Wear protective helmet in places where there
can be falling objects.
Wear protective goggles or face screens!
Use protections against noises; for example
noise reduction ear guards or earplugs.
The use of protections for the ear requests
much more attention and caution, because the
perception of danger audio signals (screamings,
alarms, etc.) is limited.
Wear anti-cut gloves.

4. FITTING THE BAR AND CHAIN

WARNING - Remove the battery before
maintenance work. Always wear work
gloves during assembly procedures. Use
only bars and chains recommended by the
manufacturer (page 33).
I
GB
F
D
E
SK
P
GR
TR
CZ
RUS
UK
PL
25