Storch Color Free Mode D'emploi page 56

The following appears in the display after one minute:
Reaction t = 6 min.
Pause button S2
The reaction time "t" runs automatically. During this
time, at t=5min, you must take a sample of the water
in the container using a clean glass to see if the reaction
results are satisfactory.
The following appears in the display after the reaction
time has elapsed:
Settling time 2 min.
Retroactive admixing S3
If the water is clear, wait until the 2 minute settling time
has lapsed.
If the water is still cloudy, it will require an additional
dose. The additional dosing command S3 is described
under section 8.1.1.!
When the 2 minutes has lapsed the system will revert to
the standby mode.
Filtration S1
Display:
and additional dosing S3
Press S1
Please wait
Display:
Pause button S2
The display message changes:
Filtration
Display:
Filtration is an automatic process until only a small
amount of water with flakes remains in the container; the
message in the display changes:
Residual filtration
Pause button S1
Residual filtration is also an automatic process until there
is no water left in the container; the pump then switches
off and the following message appears in the display:
Flushing
Start button S1
Use the STORCH spray head Art.no. 61 20 03 for flus-
hing.
Press S1. The pump starts again; the following appears in
the display:
Flushing
Stop button S1
Open the lid on the system and flush the container, the
piping, the pump and the corners and niches clean with
the spray head. The water used here is pumped to the fil-
ter. After cleaning the container, press S1.
Please wait
Display:
Pause button S2
Then the display shows:
Filtrate removal
Stop button S1
Fold up the filter pipe, remove the filter strainer with the
residual sludge and deposit it in a suitable place to drip
dry.
The press S1
Translation of the original instruction
Sampling
Filtration process
Flushing
Filter removal
56
Clear water with
flocculated matter