Technical Specification - Sunred PH10 Instructions D'emploi

Pole size between 25mm –60mm
A
Pole
Mounting Part A
Fixation Screw
Operation
Connect the power cable to a 13 ampere supply that is located in a safe, dry area.
1. The switch on the heater head is used to control the three heats setting. (Ⅰ) for 650W--- (Ⅱ) for 1300W-
-- (Ⅰ&Ⅱ) for 2000W.
2. Although the patio heater is shower proof, do not use when raining or in wet conditions.
3. Always disconnect the power cable from the electrical supply, when the patio heater is not in use.
Care and Maintenance
1. When disconnected from the electrical supply, clean the outside of the patio heater with a damp cloth .
Never use corrosive or solvent cleaners or immerse in water.
2. Any maintenance or repairs including replacing the electric halogen heater tube should only be carried
out by a qualified electrician or by a recommended service center.

Technical Specification

1. Power supply 230V ~50Hz
2. Wattage max 2000W
3. Net weight 3.60kg; Gross weight: 4.60kg
4. Insulation class I
A
B
Mounting Part B
The 0 position is off.
www.sunred.nl