Assembly Instruction - Sunred PH10 Instructions D'emploi

Wattage: 650/1300/2000 Watt
Element type: Halogen
Expected Life span elements: 5000 hrs.
Weight: 3.6 kg
Ingress Protection Rating: IP34
Certificates: CE, GS, PAH, ROHS
Cable Cord:1,9 meters
Dimensions: 100x100x8,5 cm
All measurements are approximate
IMPORTANT – Carefully remove any packaging before use, but retain the safety instructions.
These instructions are part of the product.
Please take note of all the safety warnings listed in these instructions.
Please read these instructions in their entirety and retain them for future reference.
These instructions should be stored with the product.
This product is for domestic use ONLY and should not be used commercially or for contract purposes.
Unpack the electric halogen patio heater making sure that all the items are present and that there are
no components left in the box and that the heater head is free from any packing material.
Using the detailed drawing follow the three steps to assemble your halogen heater.
Do not connect the halogen heater to the electrical supply until all the assembly is complete.
Do not connect the halogen heater to the electrical supply if any of the components or the power cord
is damaged in any way.
If in doubt contact your supplier.
EC declaration of conformity
This is to certify that
The PACHA30 Halogen Heater conforms to the standards:-
IEC/EN55014-1; IEC/EN 55014-2; IEC/EN61000-3-2;
IEC/EN61000-3-3; IEC/ EN60335-1; IEC/EN60335-2-30

Assembly Instruction

Step one: Unpack the electric halogen patio heater making sure that all the items are present
Step two: Place the Heater Mounting Part A on a Pole which diameter is between 25mm – 60mm.
Step Three: Slip the Mounting Part B and fit it to the Mounting Part A from the bottom up.
Step Four: Turn the Fixation Screw until the Mounting Part A is fixed on the pole
www.sunred.nl