Agilent Technologies Turbo-V 2300 TwisTorr Notice De Mode D'emploi page 265

This submenu contains the settings related to the set point contact
output with relay.
TYPE: the output signal can be setted referring on one of following
values:
-
-
-
-
SET VALUE, after selection of the analog output type, select the
desired value from 0000 to 9999
HYSTERESYS, if a Hysteresys value is required, it can be adjusted
between 00 and 99
MASK TIME Selectable between 00:00:00 and 99:99:99
OUTPUT LOGIC The contact logic is configured depending on
Activation Type parameter status.
-
-
Turbo-V 2300 TwisTorr Rack Controller User Manual / 87-901-044-01
FREQUENCY, default value
POWER drawn by the pump
TIME
NORMAL, when the pump has reaches Normal Operation mode
If Activation Type is "high level active" the contact is configured
as "normally open" (it will close the circuit when activated);
if Activation Type is "low level active" the contact is configured
as or "normally closed" (it will open the circuit when activated).
Technical Information
SETPOINT Submenu
265/288
17