Cub Cadet 19A30031100 Manuel De L'opérateur page 8

4. If not already installed, apply seals (720-
05151A) and (720-05152B) to the underside of
the upper grass catcher cover (731-12348D) as
shown below. See Figure 4-14.
Figure 1-14
5. From the front of the assembly, line up the
tabs on the upper grass catcher cover with
the tabs at the front of the upper chute
support. Slide the hinge pin through the
slots beginning at the right side upper chute
support of the mounting tabs, as in Figure
4-15. Push the pin all the way in until it reaches
the end-stop.
Figure 1-15
NOTE: The pin clips into place and is secured
by a tab on each side of the bagger cover.
6. Swing the upper grass catcher cover down to
close the attachment. pushing in on the rear
right-side and rear left-side tabs and lock them
into place under the notches on each side.
Ensure a secure, snug fit. See Figure 4-16.
Figure 1-16
8 S 4 — A
ection SSembly
7. Open the bagger cover by pushing in on the
tabs and lifting the upper grass catcher cover
See Figure 4-17.
8. Install both grass bag assemblies, with the
tight mesh sides facing forward, onto the bag
support brackets by inserting the front edge in
first, as shown in Figure 4-18, and setting the
back edge down until it fits into the assembly.
Installing the Deck Chute
1. Install the boot rod mount (747-06043) to the
boot using 2 shoulder screws (738-1225) and
2 flangelock nuts (712-04064) from hardware
pack 689-00636. Ensure that the shoulder
screws (738-1225) are installed on the interior
of the boot. See Figure 4-19.
& i
nStAllAtion
Figure 1-17
1
2
Figure 1-18
Figure 1-19
2. With the tractor's discharge chute raised up
and held open (1), install the chute elbow by
placing the chute elbow mounting rod into
the hole provided in either your deck wheel
bracket or chute mounting tab (2), as shown in
Figure 4-20.
1
Figure 1-20
3. Secure the chute elbow to the deck using a
wing knob (720-04122) from hardware pack
689-00312. See Figure 4-21.
NOTE: If present, remove the protective cap
off of the mounting stud on the mowing deck
as shown in the upper inset of Figure 4-21.
1
2
Figure 1-21
IMPORTANT! Be certain that the bottom of the
discharge chute is located inside of the lip of the deck
opening, as shown in Figure 4-22.
Figure 1-22
2