Cub Cadet 19A30031100 Manuel De L'opérateur page 7

Mount Assembly on Tractor (700 Series
Tractors)
1. Place the hooked ends of the mounting
assembly over the shoulder bolts, as in Figure
4-7, on the mounting brackets previously
installed on the tractor and line up the hitch
support bracket center hole with the hole on
the tractor's hitch.
Figure 1-7
2. Install the clevis pin (711-0309A) from
hardware pack 689-00312 into the tractor's
hitch and secure with a hairpin clip (714-0117).
See Figure 4-8.
Align hole on bracket
with hole on tractor
Figure 1-8
NOTE: The clevis pin can be fed down through
the hitch plate and secured underneath with
the hairpin clip, or it may be easier to feed the
clevis pin up through the hitch plate hole and
secure with the hairpin clip on the topside.
Insert the hairpin clip into the top hole, closest
to the head of the pin. You may need to push
up on the pin to make the hole accessible.
3. Install two clevis pins through the mounting
assembly and secure to the 700 series
mounting brackets installed earlier with click
pins provided in the hardware pack. See
Figure 4-8.
IMPORTANT! If you decided to leave the hitch
support only finger tight during the assembly
process, tighten all of the hardware securely
at this time.
Install the bagger hanger assembly
1. Install the upright support bracket onto the
mounting assembly on the tractor by hooking
it over the cross mounting bracket. See Figure
4-9.
2. Align the upright support bracket with the
hole labeled "C". See inset in Figure 4-9.
Figure 1-9
3. Secure the bag support assembly to the
mounting assembly using a carriage bolt
(710-0276) and wing knob (720-04122) from
hardware pack 689-00312. See Figure 4-10.
Figure 1-10
NOTE: Position "C" is the recommended
mounting position, but you may use other
mounting positions to accommodate other
attachments.
4. Install the hanger assembly onto the upright
support bracket using a carriage bolt
(710-0276) and wing knob (720-04122) from
hardware pack 689-00312. See Figure 4-11.
Figure 1-11
Assembling Remaining Bagger
Components
With the mounting brackets assembled and in place
on the tractor, follow these steps to assemble the
remaining bagger components.
1. Tilt the front of the upper chute support
slightly forward. Slide the clip behind the tab,
then snap the front latch to the rail, as shown
in (1) of Figure 4-12.
2. Snap the upper chute support in place by first
clipping the side portion onto the bagger
support rail. See (2) in Figure 4-12.
1
Figure 1-12
3. Slide the left side grass catcher cover over the
upper chute support and the bag support
assembly. Carefully latch the two tabs in place
into the front of the upper chute support, see
1 in Figure 4-13. Fit the snaps onto the left side
bagger rail support. See 2 in Figure 4-13.
1
2
Figure 1-13
S 4 — A & i
ection SSembly
2
7
nStAllAtion