Publicité
Les langues disponibles
Les langues disponibles
2.
Mounting
a)
Place the control unit as indicated in (picture 1
b)
Lay the plug & play harness under the frame (picture 1
motorcycle harness.
c)
Remove the OE-jumper of the 4-pin alarm plug, connect to the plug & play harness counterpart.
d)
Connect the 1-pin plug (picture 2
e)
Identify and disconnect the 6-pin turn signal connector (picture 3
f)
Lay the plug & play harness under the motorcycle frame and connect the corresponding plugs with the 6-pin turn
signal connectors (picture 4).
g)
Place the fuse housing (picture 5
h)
Clean the left lower frame cover carefully with a suitable cleaner.
i)
Glue the adhesive protection foil "6" and the LED to the left lower cover as shown in picture 6.
j)
Remount the left fairing and lay the LED wire under the motorcycle frame to the corresponding 2-pin plug from the
plug & play harness, connect them and fix it with the original cable tie.
k)
Connect the negative battery pole.
l)
Remount the rider's seat and the right lower frame cover.
m)
Check and test the system (3
3.
System check and test
a)
To arm the system push once BUTTON 1 of the remote control.
Arming is confirmed by:
•
2 turn indicators alternated flashing (right-left-right-left)
•
2 acoustic signals (bleep)
•
LED turns on (quick flash)
The system is operating after 40 sec. «Standby Time»: the motorbike cannot be started
b)
Move the motorbike to test that the movement sensor is operating
during 30 sec.
c)
At the end of the alarm phase the LED is steady ON.
d)
To disarm the system push BUTTON 1 of the remote control.
Disarming is confirmed by:
•
1 turn indicators alternated flashing (right-left)
•
1 acoustic signal
LED gives 1 flash every 5 sec. to confirm an alarm due to a position variation
impulse (ON-OFF) on the ignition key.
e)
To activate the PANIC alarm push once BUTTON 2 of the remote control
are flashing during 30 sec. (to stop this test push BUTTON 1 or BUTTON 2).
f)
End of installation.
4.
What to be done before delivering the motorbike to its owner
a)
Deliver to the owner the two remotes control together with the metal plate where the releasing emergency
"PIN CODE" is printed and the during installation removed OE-jumper.
b)
Explain to the owner the releasing emergency procedure
A) and press for a few seconds.
D) (+12V) to the plug & play harness counterpart.
F) and fix the plug & play harness by using the supplied tie raps (picture 5).
rd
par.)
SUZUKI GENUINE ACCESSORIES
B) to the 4-pin alarm plug (picture 2
E).
siren sounds and turn indicators are flashing
to reset the alarm memory give an
the siren sounds and turn indicators
C) of the
Led flashes slowly
3
Publicité
