Publicité
Les langues disponibles
Les langues disponibles
Ref. Description
Contents
1
2
3
4
5
6
7
Ref. Description
Tools
1
2
1.
Before
2.
installation
3.
4.
Read carefully this manual. "Special" information is described with the following symbols/words.
Important
Take care of these points.
Caution
Certain technical experience is required for the mounting. If you are not sure how to carry out the work you should
leave it to be done by your SUZUKI dealership.
1.
Preliminary operations
a)
Dismount the right lower frame cover and the saddle like it is mentioned in the owner's manual.
b)
Dismount the left lower frame cover in the same way like the right one.
c)
Disconnect the battery negative pole.
d)
Connect the plug&play harness with the control unit up to the security catch is clicking.
e)
Clean the mounting area (picture 1
f)
Apply the fixing bi-adhesive on the control unit bottom.
g)
Remove the bi-adhesive plastic film.
2
Plug & play harness
Sticky wired led 35 cm
7,5A fuse
Fixing bi-adhesive 7x5,5 cm
Tie rap 141 mm
Adhesive protection foil
Installation instructions
Cutting nipper
SUZUKI owner's manual
Park the motorbike steady in a safe place.
Keep the ignition key removed.
Be sure not to damage any vehicle part.
Check that all the parts are contained in the kit as shown in "Contents" section.
Shows risk for your life and health.
WARNING
Caution
Show risks which can damage your bike.
Note
Contain special information to fit/maintain parts easily.
A) and the back side of the unit with a suitable cleaner.
SUZUKI GENUINE ACCESSORIES
Q.ty
1
1
1
1
4
1
1
(1)
(2)
Publicité
