Candy CDI 1010 Mode D'emploi page 6

DESCRIPTION OF THE CONTROL PANEL
D
C
A
"ON/OFF" button
B
PROGRAMME DESCRIPTION
DIMENSIONS:
Height
Depth
Width
Depth with door open
TECHNICAL DATA:
EN 50242 place load
Capacity with pans and dishes
Water supply pressure
Fuse
Power input
Supply voltage
B
C
"PROGRAMME SELECTION" button
D
"PROGRAMME SELECTION"
indicator lights
cm 82 ÷ 88,5
cm 55
cm 59,8
cm 117
12
8 persons
Min. 0,08 - Max 0,8 MPa
(see rating plate)
(see rating plate)
(see rating plate)
10
PROGRAMME SELECTION
AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)
Programme settings
Open the door and place the dirty dishes
inside the appliance.
Press the "ON/OFF" button
After pressing the "ON/OFF" button, the
programme indicator lights will flash.
Choose a programme by pressing the
"PROGRAMME SELECTION" button
(PR.).
The selected programme indicator light
A
will come on.
When the "COLD RINSE" programme is
selected, 2 indicator lights will come on.
Close the door (after an audible signal
has sounded, the programme will start
automatically).
Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes) the machine stops
automatically.
Close the door, without pressing any
buttons. The cycle will start from where it
left off.
WARNING!
If you open the door during the
drying cycle, an audible audio signal
advises you that the drying cycle has
not yet finished.
Changing a running programme
Proceed as follows to change or cancel a
running program:
Hold down the
SELECTION" button until the programme
indicator lights will start to flash.
The running programme will be cancelled.
.
At this point a new programme can be set.
WARNING!
Before starting a new programme,
you should check that there is still
detergent in the dispenser.
If necessary, top up the dispenser.
If there is any break in the power supply
while the dishwasher is operating, a
special memory stores the selected
programme and, when the power is
restored, it continues where it left off.
Programme end
A 5 seconds alarm will sound (if not muted)
3 times at 30 seconds intervals to signal
that the programme has ended.
The programme indicator lights will start to
flash.
Dishes can now be removed and the
dishwasher turned off by pressing the
"ON/OFF" button or dishes can be loaded
for new cycle.
11
"PROGRAMME