Bushnell TRAILSCOUT 119833 Mode D'emploi page 13

4. K3 (Model 119833) – (24Hr / DAY/ NIGHT) MODE:
K4 (Model 119935/119905)– (24Hr / DAY / NIGHT) MODE:
The trail Scout has three operating period modes:
(a) 24Hr: The trail camera is operational both day and night. When the PiR (Passive infra Red sensor)
senses a subject, the camera will take a photo and record an EVENt.
(b) DAY: The trail camera only takes photos during the Daytime (user defined Day start~end period or
default 6am~6pm). When the PiR senses a subject, the unit will take an image and record an EVENt.
if the PiR is triggered between the Day end and Day start times, only an EVENt is recorded-an image
is not taken.
(c) NIGHT: The trail camera only takes photos during the Night (from user set Day end to Day start,
or default 6pm~6am). When the PiR senses a subject the unit will take image and record an EVENt. if
the PiR is triggered during "Day" time, only an EVENt is recorded, an image is not taken.
5. K4 (Model 119833)– (30s/1Min/2Min) CAMERA DELAY MODE
K5 (Model 119935/119905) – (30s/1Min/2Min) CAMERA DELAY MODE:
There are three modes for taking delayed pictures: 30 Sec, 1 Min and 2 Min.
The unit will record EVENtS while CAMERA is in DELAY MODE each time the PiR senses motion.
(a) 30s: After the first picture, a second picture will be taken 30 seconds later.
(b) 1Min: After the first picture, a second picture will be taken 1 minute later.
(c) 2Min: After the first picture, a second picture will be taken 2 minutes later.
Setup Guide (cont.)
13