Dometic TEC Série Notice D'utilisation page 14

Technical description
The control panel is used to operate the device (5).
The generator has an integrated battery charger for charging the connected battery.
Control elements in the connection box
The connection box is located on the generator behind the cover.
No. in
fig. 2,
Description
page 3
1 Main switch
2 Thermal protection of the
inverter
Control elements in the control panel
The control panel is installed in the vehicle interior.
No. in
fig. 3,
Description
page 4
1 Display
On/Off switch P
2
3 Green button START/STOP
4 Only TEC60:
Petrol gauge
5 Oil gauge
14
Switches the generator to standby or no
function.
Activates if the inverter overheats (see chapter
"Display messages" on page 17)
Shows the status reports.
Switches the control panel on and off if the
main switch is at "I" or "1".
Stops the generator in emergency.
Starts/stops the generator if the control panel
is switched on and the main switch is at "I" or
"1".
Lights up if the petrol goes into reserve.
Lights up if the oil level is too low in the
engine.
TEC60, TEC60LPG
EN