Demands On The Installation Location; Electrical Connection - Beem B7.001 Mode D'emploi

Initial use

Demands on the installation location

EN

Electrical connection

50
For safe and trouble-free operation of the appliance, the installation
location has to satisfy the following requirements:
■ Place the appliance on a dry, flat and heat-resistant surface.
■ Do not place the appliance in a hot, wet or very humid environ-
ment or in the vicinity of inflammable materials.
■ Select the installation location such that children cannot touch the
hot surfaces of the appliance.
■ The plug socket used must be easily accessible in order to be
able to disconnect the appliance from the electric circuit quickly in
the event of an emergency.
For safe and trouble-free operation of the appliance, the following
instructions have to be observed for the electrical connection:
■ Before connecting the appliance, compare the connection data
(voltage and frequency) on the rating plate with those of your
mains power supply. The data must correspond in order to avoid
damage to the appliance. If in doubt, ask your electrical appliance
retailer.
■ Ensure that the mains lead is undamaged and is not laid over hot
surfaces and/or sharp edges.
■ The mains lead must not be strained, kinked or come into contact
with the hot appliance.
■ Lay the mains lead in such a way that it does not pose a tripping
hazard.
■ The electrical safety of the appliance is only assured when it is
connected to a properly installed protective earth (PE) conduc-
tor system. Connection to a plug socket without PE conductor is
forbidden. If in doubt, have the house installation checked by a
qualified electrician. The manufacturer assumes no liability for
injury or damage caused by a missing or interrupted protective
earth conductor.
BEEM - Elements of Lifestyle