Motorola RDX Série Guide D'utilisation page 56

When cloning, the MUC does not need to be plugged
into a power source, but ALL radios require charged
batteries.
1. Turn ON the Target radio and place it into one of
the MUC Target Pockets
2. Power the Source radio following the sequence
below:
• Long Press the PTT button and SB2
simultaneously while turning the radio
ON.
• Wait for 3 seconds before releasing the
buttons until the audible tone "Cloning" is
heard.
3. Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Press and release the SB1 button.
4. After cloning is completed, the Source radio will
announce either "successful" (cloning is
successful) or "fail" (cloning has failed). The
'successful' tone sounds like a good key 'chirp'
whereas the 'fail' tone sounds similar to a 'bonk'
tone. If the Source radio is a display model, it
54
English
will either show 'Pass' or 'Fail' on the display (a
tone will be heard within 5 s).
5. Once you have completed the cloning process,
turn the radios OFF and ON or, long press the
PTT button to exit the 'cloning' mode.
Further details on how to clone radios are explained in
the Instructions Sheet provided with the MUC.
When ordering the MUC, refer to part number
RLN6309_.
Note:
• If cloning fails, refer to "What To Do If Cloning
Fails" on page 56.
• Paired Target radios and Source radios must be
of the same band type in order for the cloning to
run successfully.
• MUC pockets numbers should be read from left to
right with the Motorola logo facing front.