What To Do If Cloning Fails - Motorola RDX Série Guide D'utilisation

'chirp' whereas the 'fail' tone sounds similar to a
'bonk' tone. If the Source radio is a display
model, it will either show 'Pass' or 'Fail' on the
display (a tone will be heard within 5 seconds).
8. Once you have completed the cloning process,
turn the radios OFF and ON to exit 'clone'
mode.

What To Do If Cloning Fails

The radio will emit an audible "bonk" indicating that
the cloning process has failed. In the event that the
cloning fails, perform each of the following steps
before attempting to start cloning process again:
1. Ensure that the batteries on both radios are fully
charged.
2. Check the cloning cable connection on both
SUCs.
3. Ensure that the battery is engaged properly on
the radio.
4. Ensure that there is no debris in the charging
tray or on the radio contacts.
5. Ensure that the Target radio is turned ON.
56
English
6. Ensure that the Source radio is in cloning mode.
7. Ensure that the two radios are both from the
same frequency band, same region and have
the same transmission power.
Note: This cloning cable is designed to operate
only with compatible Motorola SUC
RLN6175_ and RLN6304_.
When ordering Optional Cloning Cable, please refer
to part number RLN6303_. For more information
about the accessories, refer to "Accessories" on
page 75.