Domo DO9098W Mode D'emploi page 22

DO9098W
ENERGY SUPPLY
• this scale operates on solar power. it also functions with daylight or lamplight.
when the scale is standby, the 0 will blink on the display.
• Do not cover the solar panels during use.
• if the light is too faint, the scale will switch off due to a lack of energy. move
the scale to another spot with brighter light and wait until the scale switches on
automatically to continue weighing.
• the scale should not be placed in a spot with light fainter than 70 lux to function
optimally.
OPERATION
1. Place the scale on a hard, flat surface and avoid carpet or soft surfaces to
guarantee the precision of the scale. also make sure that there is nothing
underneath the scale before weighing.
2. make sure that the scale is placed in the light - sunlight or lamplight - and
that the solar panels of the scale are not covered. if the lcD screen does not
display a blinking 0, turn on the light or move the scale to another place with
an illumination no fainter than 70 lux. the scale will switch on again after
approximately 60 to 90 seconds. the stronger the light, the less time the scale will
need.
3. the scale needs to be in standby. You will recognize the standby mode by the
blinking 0 on the lcD display.
4. calmly step on to the scale. the display will show a dash - , which means that
the scale is weighing. wait for about 3 seconds. the scale will now indicate your
weight.
5. You will be able to read your weight from the lcD display during approximately
12 seconds.
solar panels
22