Table des Matières
Publicité
LED FLASHES
Message transmission.
The Error codes are signalled by the RED Standby LED.
Count number of flashes : error code is signalled in two
burst separated by a 0.7 s pause and repeated several
times.
There is 1.7 s between each code sequence .
orange pause
0,7 sec.
1,7 sec.
2
4
0,7 sec.
1,7 sec.
green pause
250ms
red pause
0,7 sec.
1,7 sec.
3
4
0,7 sec.
1,7 sec.
off pause
GENERAL INFORMATION - LED BEHAVIOUR
CODES
10
11
12
13
14
15
16
17
18
19
20
21
23
25
26
27
28
29
green
31
32
orange
34
35
250ms
36
37
38
off
39
red
41
42
43
44
45
46
47
48
49
DEFAULT
Display effective child lock mode
Display timer mode
Audio-MSP doesn't answer anymore
Audio-Dpl doesn't answer anymore
TDA9330H doesn't answer anymore
TDA9321 doesn't answer anymore
DMU0 doesn't answer anymore
SAA4956 doesn't answer anymore
TDA9178 doesn't answer anymore
Tuner doesn't answer anymore
I2C Bus is loocked
I2C Bus data line held low
I2C Bus clock line held low
Switched 5V not available
Tube gets not warm in time
Deflection detects >3 times prot
Vertical deflection safety is effective
Horizontal deflection safety is effective
Call with pointer that was not allocated
A software-timer has been requested but isn't
available yet
The NVM chip doesn't answer anymore
5V and 8V not available
Wrong address passed to the bus-handler
Unexpected level on NMI line found
Heap full - There is no RAM available for
the requested operation
I2C Bus data line not recoverable
Power down detection TDA9178 (PSI)
Power on reset error TDA9320 (HIP)
Power on reset error TDA9330 (HOP)
NRF bit problem (only factory information)
FLS bit problem (only factory information)
NHF bit problem (only factory information)
NDF bit problem (only factory information)
XPR bit problem (only factory information)
Problem with bits SXA...D (factory information)
Publicité
Table des Matières
