Instructions; Time Mode; Setting The Time And Measurements; Changing The Display - Timex EXPEDITION WS4 Mode D'emploi

6. To calibrate the weather to the preselected data, hold STOP/RESET until
the watch beeps.

INSTRUCTIONS

TIME MODE

Your watch shows the time for two time zones. In this mode, you can also
choose measurement units (i.e., feet or meters; Fahrenheit or Celsius) and
pick from three different display options.

Setting the Time and Measurements

1. Press MODE until time of day is displayed.
2. Press and hold SET to start.
3. Press START/SPLIT (+) or STOP/RESET (-) to increase or decrease set-
ting values for time zone, time, date, sounds, and measurements.
4. Press MODE (NEXT) to advance to the next setting option.
5. Press SET (DONE) to finish.
14

Changing the Display

• Times Zones: Look at the other time zone by pressing START/SPLIT or
switch time zones by holding START/SPLIT.
• When in Time of Day Mode, press STOP/RESET to choose among the
following display options: Date, Altitude, or Barometric Pressure.

ALTIMETER MODE

Your watch allows you to track current, peak, and accumulated altitude as
well as time spent at or above a target altitude. This mode also includes an
alarm if you want to be alerted when you go above an altitude of your
choosing. You should calibrate the altimeter before first use (see page 38).

Operating the Altimeter

Once in Altimeter Mode, the WS4
™
• PEAK: The highest reached altitude.
• ACC (accumulated): The total altitude change, taking both ascent and
descent into account.
• CURR (current): The current altitude.
watch automatically scrolls through:
E
15