Operating Environment - NEC PlasmaSync 42XM5 Manuel D'utilisation

Masquer les pouces Voir aussi pour PlasmaSync 42XM5:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 99
NOTE:
When you use an RGB cable (not supplied), use an RGB
cable including the ferrite core (not supplied) on both ends
of the cable. If you do not this, this monitor will not
conform to mandatory CE or C-Tick standards.
NOTE:
When you use the power cable (supplied), use the supplied
ferrite cores. Set the ferrite cores (supplied) on both ends
of the power cable (supplied), and then use the bands
(supplied) to fasten the ferrite cores (supplied) to the power
cable (supplied). If you do not this, this monitor will not
conform to mandatory CE or C-Tick standards.
Power cable (supplied)
NOTE:
When you use a remote cable (not supplied), use the
supplied ferrite core. Wind the remote cable (not supplied)
around the ferrite core (supplied) once, and then fasten
the catch. If you do not this, this monitor will not conform
to mandatory CE or C-Tick standards.
Remote cable (not supplied)
To plasma monitor
This product complies with the Low Voltage Directive
(73/23/EEC, amended by 93/68/EEC), EMC Directives
(89/336/EEC, amended by 92/31/EEC and 93/68/EEC).
Downloaded From TV-Manual.com Manuals
band
band
core
core
core
WARNING
This product equipped with a three-wire grounding
(earthed) plug - a plug that has a third (grounding)
pin. This plug only fits a grounding-type power
outlet. If you are unable to insert the plug into an
outlet, contact a licensed electrician to replace the
outlet with a properly grounded one. Do not defeat
the safety purpose of the grounding plug.

Operating Environment

Operating environment temperature and humidity:
0 °C to +40 °C (+32 °F to +104 °F); less than 80
%RH (cooling vents not blocked)
Do not install this unit in a poorly ventilated area,
or in locations exposed to high humidity or direct
sunlight (or strong artificial light)
Disposing of your used
product
EU-wide legislation as implemented in each
Member State requires that used electrical and
electronic products carrying the mark (left) must
be disposed of separately from normal household
waste. This includes plasma monitors and their
electrical accessories. When you dispose of such
products, please follow the guidance of your local
authority and/or ask the shop where you purchased
the product.
After collecting the used products, they are reused
and recycled in a proper way. This effort will help
us reduce the wastes as well as the negative impact
to the human health and the environment at the
minimum level.
The mark on the electrical and electronic products
only applies to the current European Union Member
States.
CAUTION
When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country/area.
En-3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Plasmasync 50xm6Plasmasync 60xm5Px-42xm5gPx-50xm6gPx-60xm5g

Table des Matières