Installing Stainless Steel Handle - Avanti WBV19DZ Manuel D'instructions

Ø INSTALLING STAINLESS STEEL HANDLE
This wine chiller includes a stainless steel handle that is not required to operate this unit. To install the
handle please follow the below instructions:
1. Pull away the door gasket in the area where the handle is to be installed as shown below in
Illustration # 1. The gasket is easily displaced by hand, no tools are necessary.
2. Align the handle with the screws pre-installed on the backside of the door. Tighten the
screws using a Phillips head screwdriver until the handle sets both flush and secured tightly
against the door frame. (DO NOT overtighten as this will cause damage to the handle
assembly).
3. Replace the door gasket to its original position.
① G asket ② Screwdriver
10
③ S/S Handle