Maintenance - Haussmann Xpert 5848005 Manuel De L'utilisateur

GENERAL MAINTENANCE
WARNING
• For your own safety, turn switch OFF and remove the
plug from power source receptacle before maintaining,
cleaning, adjusting, or lubricating your sander.
• To avoid fire or toxic reaction, never use gasoline,
naphta, acetone, lacquer thinner or similar highly
volatile solvents to clean the sander.
• To avoid eye injury from blowing debris, wear safety
goggles when blowing out sawdust.
CLEANING
Keep sander and workshop clean. Do not allow sawdust
to accumulate on the tool. Keep the drums clean. Dirt on
drums will cause poor tracking and belt slippage. Periodi-
cally empty the dust collection bag.
Be certain motor is kept clean and is frequently vacuumed
free of dust.
Use soap and water to clean painted parts, rubber parts
and plastic guards.

MAINTENANCE

LUBRICATION
The shielded ball bearings in this have been are
permanently lubricated at the factory. They require no
further lubrication.
• When operation seems stiff, a light coat of paste wax
applied to the table will make it easier to feed the work
while finishing.
• Do not apply wax to the belt platen. Belt could pick up
wax and deposit it on wheels causing belt to slip.
TOOL REPAIRS
• If power cord is worn, cut, or damaged in any way, have
it replaced immediately.
• Replace worn abrasives when needed.
• Replace any damaged or missing parts. Use parts list
to order parts.Any attempt to repair motor may create a
hazard unless repair is done by a qualified service
technician. Call the customer service line at
1-866-599-5916 ext. 2 for assistance.
23