Important; Before Use - Tanita KP-601 Mode D'emploi

IMPORTANT

1. Use in location where there is little vibration
2. If the change in temperature exceeds 5 °C ( 10 °F), wait at least 30 minutes before use.
3. Use on a hard flat surface confirming that it is level using the bubble level.
4. To prevent wind from affecting measurement, close cover.
5. Do not dismantle.
6. Clean using mild detergent. Chemical should not be used.
7. Always use the provided Gem cup.
NAMES OF PART
1 Wind sheild (cover) 9 Stable mark
2 Hinge 0 Minus sign
3 Gem cup q Calibration mark
4 LCD display (front) w Weighing modes
5 LCD display (back, option) e ON/OFF button
6 Test weight r TARE button
7 Open button t CALIBRATION button
8 Lo battery mark y MODE button
2
s
u AC adaptor inlet
i Adjustable feet
o Battery compartment
p USB port (option)
a Level
s AC adapter (option)
d USB cable (option)

BEFORE USE

When using with batteries
◆
1. Open the battery cover.
2. Remove the battery cover and insert 4 size AA (LR6) batteries.
3. Replace the battery cover.
When using with AC adaptor
◆
1. Do not use any AC adaptor except those with the following specification.
* Only use an AC adaptor with a CE marking
2. To use AC adaptor, put the DC jack into the inlet.
Check the level to make sure that the scale is horizontal.
◆
1 2
Adjust so that the
bubble is the center
circle.
Note: Make sure all 4 feet make contact with surface.
How to remove and attach the cover
◆
[How to remove]
1 2
Push the hinge to Twist and pull it up.
one side.
3 4
Adjust with the
adjustable feet.
[How to attach]
1 2
Insert one side of Twist and pull it
hinge. down.
3