Pump Saver - Blue Clean AR 383 Manuel Du Propriétaire

Fig. 22
Fig. 24
En - 12
93248_Modelo AR383.indd 12
• The pressure hose is stored on the hose reel located
above the accessory holder. With the front of the power
washer facing towards you, insert the un-threaded end of
the power hose into the square hole on the inner reel and
begin turning the handle away from you (Fig. 23). After
inserted into the square hole, place the hose under the
indentation on the side of the reel to keep it in place while
Fig. 23
winding it up (Fig. 24). when finished winding, push the
handle in to lock it in place. Please remember: the hose
reel is only for storing the high pressure hose. The hose
must be completely removed from the hose reel each time
you use the power washer.
• DO NOT store the power washer where it is exposed
to freezing temperatures unless you use Pump Saver.
It is recommended that you use Pump Saver for storing
in freezing temperatures. Freezing will damage the pump
unless Pump Saver is added to the power washer. If not
using or if storing your power washer for more than one
month, run Pump Saver through it. See the section on
Pump Saver for more information.
P
UMP
Pump Saver is a product that protects and prolongs the life
of the pump. This will keep the internal parts of the pump
lubricated and protected from freezing while being stored in ALL
climates. It also assists with protection from internal corrosion.
The Blue Clean part # is: PW64511 (16oz. bottle ).
Pump Saver Instructions
Follow the previous storage instructions for your power washer. To
prevent staining, protect the surface under the power washer from
any excess fluid. Wear eye protection when using this product.
Turn unit off and disconnect the gun before adding pump protector.
Unscrew threaded top from bottle to remove seal and reattach
threaded top to bottle. Remove black cap from bottle.
1) Place top of pump saver bottle onto the garden hose adaptor
previously installed to pressure washer inlet.
2) Secure pump saver bottle by turning in a clockwise direction.
3) Turn power on. Turn the power washer off as soon as the Pump
Saver begins to exit the HP hose.
4) Squeeze bottle to help it into the pump.
5) Turn power off when pump saver exits the machine's water outlet.
Note: Instructions on Pump Saver Bottle are generic and not model
specific.
S
AVER
2018/3/7 上午10:53