Silverline 129659 Mode D'emploi page 8

GB
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure,
or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an
authorised Silverline service centre
Note: One set of Spare Carbon Brushes is supplied with this tool.
• To replace the brushes:
1. remove the Brush Access Caps (11) from both sides of the machine
2. Remove the worn brushes and replace
3. Replace the Brush Access Caps
• Alternatively, have the machine serviced at an authorised Silverline
service centre
Hook and loop surfaces
• Hook and loop surfaces need to be clean, free of dirt and foreign matter,
such as hair, fibres, sand etc.
• In order to provide adequate adhesion for securing accessories, hook and
loop surfaces must be in good condition
• When used extensively, hooks and loops will become elongated or
broken, and the mechanism cannot provide the required strength of
adhesion anymore
Note: This sander's Hook & Loop Backing Pad (10) is NOT a warranty item.
Replacements can be obtained from www.toolsparesonline.com.
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
8