Useful Information - Atlas Copco RRC13 Manuel D'instructions

RRC13
Maintenance
Lubrication
The tool should be lubricated with about 10 drops of oil once per shift. The oil
can be dropped either into the air hose or straight through the adapter (16).
When the tool is in continuous service, installation of an Atlas Copco oil-fog lu-
bricator in the compressed air line is recommended.
Use lubricants of good quality. The oils listed in the lubrication table are exam-
ples of lubricants that can be recommended.
Grease guide
Brand
BP
Esso
Q8
Mobil
Shell
Texaco
Molycote
Overhaul
If the tool is used every day, it should be overhauled and cleaned once every six
months.
The filter in the adapter (16) should be cleaned frequently to prevent choking
with resultant decrease in capacity.

Useful information

Log in to Atlas Copco www.atlascopco.com
You can find information concerning our products, accessories, spare parts and
published matters on our website.
Ergonomic guidelines
Consider your workstation as you read through this list of general ergonomic
guidelines and see if you can identify areas for improvement in posture, compo-
nent placement, or work environment.
• Take frequent breaks and change work positions frequently.
• Adapt the workstation area to your needs and the work task.
• Adjust for convenient reach range by determining where parts or tools
should be located to avoid static load.
• Use workstation equipment such as tables and chairs appropriate for the
work task.
• Avoid work positions above shoulder level or with static holding during as-
sembly operations.
EN
Grease
Energrease LS-EP2
Beacon EP2
Rembrandt EP2
Mobilegrease XHP 222
Alvania EP2
Multifak EP2
BR2 Plus
© Atlas Copco Industrial Technique AB - 9836 978500 00
Safety and operating instructions
Air lubrication
Energol E46
Arox EP46
Chopin 46
Almo Oil 525
Torcula 32
Aries 32
9