Useful Information - Atlas Copco P2530-H Manuel D'instructions Original

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

P2530-H

see front page) and in combination with our accessor-

ies, to which this declaration relates is in conformity

with the appropriate standard(s):

EN 792-4

and in accordance with the following directive(s):

2006/42/EC

Technical file available from:

Quality Manager, Atlas Copco Tools, Stockholm,

Sweden

Stockholm, 29 December 2009

Lennart Remnebäck, General Manager

Signature of issuer

Installation

Air quality

• For optimum performance and maximum machine

life we recommend the use of compressed air with

a maximum dew point of +10°C. We also recom-

mend the installation of an Atlas Copco refrigera-

tion-type air dryer.

• Use a separate air filter of type Atlas Copco FIL.

This filter removes solid particles larger than 15

microns and also removes more than 90 % of li-

quid water. The filter must be installed as close

as possible to the machine/equipment and prior

to any other air preparation unit such as REG or

DIM (please see Air Line Accessories in our main

catalogue). Blow out the hose before connecting.

Models which need air lubrication:

• The compressed air must contain a small quantity

of oil.

We strongly recommend that you install an Atlas

Copco oil-fog lubricator (DIM). This should be

set according to air consumption by the air line

tool according to the following formula:

L = Air consumption (litre/s).

(May be found in our sales literature).

D = Number of drops per min (1 drop = 15 mm

L* 0.2 = D

this applies to the use of long work cycle air line

tools. A single point lubricator type Atlas Copco

Dosol can also be used for tools with short running

cycles.

Information about Dosol settings may be found

under Air Line Accessories in our main catalogue.

Lubrication-free models:

• In the case of lubrication-free tools it is up to the

customer to decide on the peripheral equipment

to be used. However, it is no disadvantage if the

compressed air contains a small quantity of oil

e.g. supplied from a fog lubricator (DIM) or Dosol

system. This does not apply to turbine tools, which

should be kept oil free.

Compressed air connection

• The machine is designed for a working pressure

of 6–7 bar = 600–700 kPa = 87–102 psi.

• Blow out the hose before connecting.

Maintenance

Lubricate the machine regularly with air tool oil.

If the machine is used every day, it should be

overhauled and cleaned once every six months.

The use of other than genuine Atlas Copco replace-

ment parts may result in decreased tool performance

and increased maintenance and may, at the option

of the company, invalidate all warranties.

Cleaning

At 100 hour operating intervals or earlier if operation

becomes sluggish or the machine shows sign of

sticking, flush through with paraffin or a similar

material. Immediately after flushing thoroughly oil

the machine with air tool oil.

Grease guide

Brand

Esso

Mobil

Shell

Texaco

Molycote

)