Panasonic TY-CE85PS12 Manuel D'installation page 20

Assembly
1. Install the base
Install one prepared base
1. Insert the column
(With the sticker displaying the parts number facing down,
insert the column
2. Fasten in place with two prepared M8 bolts (60 mm)
nuts .
•
The bolt should be securely tightened to the torque given
below.
(7~10 N•m)
2. Install plates
Install prepared plates
1. Secure the column
prepared M8 bolts (60 mm)
•
The bolt should be securely tightened to the torque given
below.
(7~10 N•m)
3. Assemble the frame
1. Insert the frame
prepared M16 bolt
2. Secure the stay
prepared M8 bolts (60 mm)
•
The bolt should be securely tightened to the torque given
below.
(M16 bolt 16~20 N•m
M8 bolt 7~10 N•m)
4. Install onto the Plasma Display.
Install each column assembled in the above step 2 onto the
display.
1. Prepare six sets of one M16 bolt
one plain washer
shown in the right figure.
2. Place each column on the display, and temporarily fix it with
prepared bolts from the top down.
3. Confirm that the each column has been properly seated on the
display, and then tighten the bolts securely.
•
The bolt should be securely tightened to the torque given
below.
(16~20 N•m)
20
on the column .
on each column
between the side plates of the base
into the base .)
on the column .
on each column
to the prepared plates
and nuts
and the stay .
into stay , and secure it using the
and the nut .
to the prepared plates
and nuts
, one spring washer
, which should be assembled in the order
.
.
and
.
using the
.
using the
.
and
Parts number sticker
1
2
Prepared M8 bolt (60 mm)
Prepared M8 bolt
(60 mm)
Prepared M8 bolt (60 mm)
Prepared
M16 bolt
2
1
Column
Plasma Display
1
2
3