Operation Clts60Rgbw - Cameo CLTS40WW Manuel D'utilisation

OPERATION CLTS60RGBW

NOTE:
When the spotlight is properly connected to the mains, the following information appears successively on the display during the startup
process: "Update Wait ..." (only for service purposes), "Welcome to Cameo", "Fresnel" and the software version. After this step, the spot is
ready for operation and the operating mode that was previously selected is activated.
MAIN DISPLAY DMX MODE
In the upper line of the display, "DMX Addr" is displayed and in the lower line the currently set DMX start address. As soon as the DMX sig-
nal is interrupted, the display starts flashing; if the DMX signal is present again, the display stops flashing. The main display is automatically
activated if no input is made within about 30 seconds.
MAIN DISPLAY STANDALONE MODE
In the lower line of the display, the currently set operating Standalone mode is displayed (Sound, Slave, Auto, Static, Macro). The main
display is automatically activated if no input is made within about 30 seconds.
SETTING THE DMX MODE
Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "Mode" (lower line) and
confirm with ENTER. Now use the UP and DOWN buttons once more to select the "DMX" sub-menu item and confirm by pressing ENTER.
Using UP and DOWN, select the desired DMX mode (3CH, 4CH, 5CH, 7CH, 13CH) and confirm with ENTER. Press MENU once more to return
to the main display. The main display is automatically activated if no input is made within about 30 seconds. You will find tables with the
channels of the different DMX modes in this manual under DMX CONTROL.
SELECTING THE DMX START ADDRESS
Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "DMX Addr" and confirm
with ENTER. Now you can select the DMX start address as desired by using the UP and DOWN buttons. Confirm with ENTER and press
MENU once to return to the main display. The main display is automatically activated if no input is made within about 30 seconds.
MUSIC CONTROL MODE
Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "Mode" (lower line) and
confirm with ENTER. Now use the UP and DOWN buttons once more to select the "Sound" sub-menu item and confirm by pressing ENTER.
The Music Control mode is now activated and you can set the sensitivity to which the spotlight reacts to noise (bass pulses) as desired
using the UP and DOWN buttons (Mic Sens 00 - 99). Confirm with ENTER and press MENU once more to return to the main display. The
main display is automatically activated if no input is made within about 30 seconds.
SLAVE MODE
Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "Mode" (lower line) and
confirm with ENTER. Now use the UP and DOWN buttons once more to select the "Slave" sub-menu item and confirm by pressing ENTER.
9