Signal Input On Telestart T80; Digital Timer; Pushbutton Switch; Switchover Of Signal Input - Webasto Telestart T80 Notice De Montage

Telestart T80

Signal input on Telestart T80

In addition to the Telestart, a digital timer or
a pushbutton switch can be installed.
Caution:
The digital timer and the pushbutton switch
transmit differing signals to the Telestart re-
ceiver!
The signal input must be adapted to the ap-
propriate heater control!
By default, the signal input of the Telestart
receiver is tuned to the digital timer!
16

Digital Timer

When the heater is activated (by pressing
the instant heat button or by the start of a
preset heater operating time) the Telestart
receives a continuous plus signal from the
digital timer during the entire operating
time.
Upon deactivation of the heater (by press-
ing the instant heat button or when the end
of the operating time preset on the digital
timer is reached), the voltage supply is cut
off and the heater is switched off.

Pushbutton Switch

Upon switching on or off using the pushbut-
ton switch, the Telestart receiver receives a
short plus signal.
For the Telestart to be able to recognize
this signal, the signal input needs to be
tuned to the pushbutton switch.
If the signal input is not switched over to the
pushbutton switch, the heater will not turn
on.
Switchover of Signal Input from
Digital Timer to Pushbutton
Switch
- Remove fuse 1A (black) from the
heater's fuse holder (voltage cutoff).
- Wait at least 5 seconds.
- Install fuse in heater's fuse holder and
briefly actuate the pushbutton switch
2x within 5 seconds.
- Switchover is terminated.
Switchover of Signal Input from
Pushbutton Switch to Digital
Timer
- Remove fuse 1A (black) from the
heater's fuse holder (voltage cutoff).
- Wait at least 5 seconds.
- Install fuse in heater's fuse holder and
briefly actuate the instant heat button
on the digital timer within 2 seconds
(display back lighting is illuminated).
- After 10 seconds briefly actuate the
instant heat button (display back
lighting is extinguished).
- Switchover is terminated.