Power Sources - Citizen JCTV1586 Manuel D'instructions

REMOTE CONTROL
BATTERY INSTALLATION
Slide the battery compartment cover.
Install two "AAA" batteries, paying attention to the
polarity diagram in the battery compartment.
Replace the compartment cover.
BATTERY PRECAUTIONS
The precautions below should be followed when using
batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing
the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Al-
kaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of
time, remove the batteries to prevent damage or
injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be
recharged; they can overheat and rupture (Follow
battery manufacturer's directions).
EFFECTIVE DISTANCE OF THE RE-
MOTE CONTROL
30˚ 30˚
•
NOTES: When there is an obstacle between the TV/
VCR and the remote control, the remote
control may not operate.
•
When direct sunlight, an incandescent lamp,
fluorescent lamp or any other strong light
shines on the Remote sensor of the TV/
VCR, the remote operation may be unstable.
10
15 FEET (5m)

POWER SOURCES

Use the AC polarized line cord provided for operation on
AC. Insert the AC cord plug into a standard 120V 60Hz
polarized AC outlet.
NOTES:
•
Never connect the AC line cord plug to anything other
than the
specified voltage (120V 60Hz). Use the attached power
cord only.
•
If the polarized AC cord does not fit into a
nonpolarized AC outlet, do not attempt to file or cut
the blade. It is the user's responsibility to have an
electrician replace the obsolete outlet.
•
If you cause a static discharge when touching the unit,
and the unit fails to function, simply unplug the unit
from the AC outlet, wait 10 minutes, and plug it back
in. The unit should return to
normal operation.
Wider Hole
and Blade
Polarized AC Cord Plug
(One blade is wider than the other)
TO USE DC POWER
By using the DC car cord supplied with the TV/VCR, you
can operate this TV/VCR from a cigarette lighter socket
in any car that utilizes a negative ground system.
The fused 12V DC car cord has been designed to power
the set from the external DC power (12 volt negative
ground) through the TV/VCR DC input jack.
Connect the smaller plug on the end of the cord to the
DC input jack on the rear of the TV/VCR, then insert the
other end of the car cord into the cigarette lighter socket
of your car. Make sure that the cord makes a firm
connection.
It may be necessary to try several insertions, rotating
the plug for proper electrical connection.
TV/VCR
AC Outlet
CAR
To Cigarette
Lighter Socket
To DC Input Jack
Car Cord (supplied)