Porter Cable PCB370SS Manuel D'instructions page 13

INSTALLING FEED HANDLES (FIG. E)
1. Bag "E" - Locate the three feed handles (1) in the
loose parts bag.
2. Screw the feed handles (1) into the threaded hole (2)
of the right hub assembly (3) and tighten.
NOTE: The feed handles can be installed on either
the right-hand side or left-hand side.
Fig. E
1
2 3
INSTALLING THE CHUCK (FIG. F, G, H)
WARNING
!
Before any assembly of the chuck and arbor to the
drill press head, clean all mating surfaces with a non
petroleum based product; such as alcohol or lacquer
thinner. Any oil or grease used in the packing of these
parts must be removed otherwise the chuck may come
loose during operation.
1. Bag "D, F" - Push the chuck (1) onto the spindle
arbor (2). Tap gently on the arbor with a rubber
hammer to ensure a proper seat.
Fig. F
2. Lower the spindle by turning the feed handles (3)
counterclockwise, until the slot (4) appears on the
quill (5).
3. Push the chuck and spindle arbor up into the
spindle, making sure the tang (6) (upper narrow end
of the spindle arbor shank) is engaged and locked
in the inner slot (7) of the spindle. This can be seen
through the outer slot (4) of the quill by rotating the
chuck and arbor until the two slots are aligned.
4. Open the jaws of the chuck (1) by rotating the chuck
sleeve clockwise. To prevent damage, make sure the
jaws are completely receded into the chuck.
NOTE: Clean the taper with a non-alcohol based
cleaner before inserting it into the arbor.
2
1
Fig. G
4
6
7
5
2
1
5. Using a rubber mallet, plastic-tipped hammer, or a
block of wood and a hammer, firmly tap the chuck
upward into position on the spindle shaft.
Fig. H
INSTALLING THE BULB (FIG. I)
NOTE: Bulb is not included.
1. Install a light bulb (1) (no larger than 40 watt) into the
socket.
WARNING
!
● For your own safety, never connect plug to
power source outlet until all assembly steps are
complete and you have read and understood the
safety and operating instructions.
● To prevent injury resulting from heat of the light
bulb. Never touch the light bulb.
● To prevent electric shock. Never touch the bulb
socket when the plug from the power source is
connected.
Fig. I
ON/OFF SWITCH
1
13
3