Device-Specific Safety Instructions; Your Device At A Glance; Scope Of Delivery; Unpacking And Commissioning - wepump WEPRESS Mode D'emploi

Device-specific safety instructions

• Do not subject the device to rain. Do not use the device in wet surroundings.
• Do not use the device in areas where there is danger of explosion or in the vicinity of com-
bustible liquids or gases!
GB
• Do not aim the water jet directly toward the device or other electrical components! Mortal dan-
ger due to electric shock!
• Lay the extension cord in such a way that it cannot get into the liquid being conveyed.
• Do not install and switch on the unit when there are people or animals in the medium to be
conveyed (e. g. swimming pool) or have contact with such.
• Do not leave the unit unattended. If leaving it for any period of time, unplug.
• As a general rule, repairs are only to be carried out by an electrician. If repairs are performed
improperly, there is danger of liquid getting into the electronic components of the device.
• Symbols affixed to your tools may not be removed or covered. Information on the device that
is no longer legible must be replaced immediately.
Read and observe the operating instructions before commissioning.

Your device at a glance

3. Manometer (boiler pressure)
4. Braided Hose
5. Intake
6. Pump cover
7. Pressure joint
8. On-Off switch (back side)
9. Compressed air valve
10. Base feet
11. Power cable & plug

Scope of delivery

• Domestic water works
• Instructions for use

Unpacking and commissioning

Setting up

• The device must be placed on a horizontal, level surface that is sufficiently capable of sup-
porting the total weight of the device when filled with water.
• To prevent vibrations, the device should be placed on an elastic base [support] (e. g. a rubber
mat).
20
4
Your device at a glance
GB