Description - Niko Easywave 05-351 Mode D'emploi

05-351 / 05-352 / 05-336 / 05-300

1. DESCRIPTION

This Easywave transmitter is part of the Niko RF (Radio Frequency) system, an installation
technique that does not require any wiring between the control points (push buttons) and the
consumers to be operated. This technique is known as 'remote control' or 'wireless control'.
Transmission occurs by means of radio waves at the 868.3MHz frequency. This frequency is
reserved for products that do not transmit continuously (1% per hour = 36s.), so that there is
only a minimal risk of interference. The system is therefore ideally suitable for use in specific
applications such as renovation of interiors, extensions in existing electrical installations
where drilling or channeling work is excluded, offices with movable walls... or to avoid the
use of complex cabling configurations. It is a modular system built around transmitters and
receivers. The wall mounted transmitters take the form of an ordinary switch that can be wall
mounted. The hand held transmitters take the form of a conventional remote control unit. Each
transmitter can control an unlimited number of receivers simultaneously. Each receiver can
be controlled by up to 32 transmitters.
ATTENTION! When mounting the receiver in a metal distribution box, external antenna 05 -309
has to be used. The antenna does not extend the available range. Through-feed opening for
the connector ±15mm.
EN 53