General Information - Napoleon HD81-1 Instructions D'installation Et D'opération

2.3

GENERAL INFORMATION

FOR YOUR SATISFACTION, THIS APPLIANCE HAS BEEN TEST-FIRED TO ASSURE ITS OPERATION
AND QUALITY!
Altitude (FT)
Max. Input (BTU/HR)
Max. Output Steady State (BTU/HR)
Effi ciency (w/the fan on)
Min. Inlet Gas Supply Pressure
Max. Inlet Gas Supply Pressure
Manifold Pressure (Under Flow Conditions)
This appliance is approved for bathroom, bedroom and bed-sitting room installations and is certifi ed for
mobile home installation.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certifi ed kit is used.
When the appliance is installed at elevations above 4,500ft (1371m), and in the absence of specifi c
recommendations from the local authority having jurisdiction, the certifi ed high altitude input rating shall be
reduced at the rate of 4% for each additional 1,000ft (305m).
The switch on the battery holder must be placed in the middle position. If this switch is not in this
position the appliance will not operate using the remote, see "REMOTE RECEIVER INSTALLATION" and
"CONTROL MODULE REMOVAL" section.
Expansion / contraction noises during heating up and cooling down cycles are normal and are to be
expected. Change in fl ame appearance from "HI" to "LO" is more evident in natural gas than in propane.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room temperature
but this can be improved if the assembly is warmed, using a hair dryer or similar heat source.
This appliance is equipped with a remote control system, which requires batteries (supplied) to be installed.
The transmitter takes 3 "AAA" batteries and in the case of a power failure the battery back-up takes four
"AA" batteries.
HD81-1
NG
0-4,500
60,000
38,753
64%
4.5" w.c. (11mb)
13" w.c. (32mb)
3.5" w.c. (9mb)
65%
HD81-1
7
EN
P
0-4500
50,000
33,677
68%
11" w.c. (27mb)
13" w.c. (32mb)
10" w.c. (25mb)
W415-2201 / A / 12.14.16