SPORTSTECH F75 Mode D'emploi page 48

STEP 3:
1. Two people are recommended for assembly in order to easily assemble the console segment on the side panels.
At first, put the console segment on only slightly so that you can connect the cable from the console with the cable
from the side part. The plug must be tight. Briefly switch on the device to check whether the connection of the
cables is correct.
2. If it functioning okay then carefully insert the cable into the side part and place the console segment correctly on
the side parts without pinching or twisting the cable.
3. Attach the bracket segment to the side panels with # 64 screws and # 85 washers.
4. Loosen the transport lock # 8, which is located below the running surface and attached to the frame on the left
side. Remove this and the two # 65 screws.
STEP 4:
1. Mount the covers on the left and right at the top of the side panels with screws # 79.
2. At the lower end of the side panels screw the cover, which is intended for the inside, to the stand frame. Use screws
# 79 for this.
3. Screw the cover sleeve for the outside with the inner cover and the side panel together. Use screws # 79 for the
two covers and screws # 80 for the connection between the cover and the side panel.
48