Displaying 3D Images - Sharp LL-151-3D Mode D'emploi

Notices on displaying 3D images
- Set the screen resolution to 1024 x 768.
It is unable to display 3D image with other
setting.
- Be sure to connect the USB cable while the
monitor and computer are turned off. Then, turn
on the monitor first and finally turn on the
computer.
- Do not connect/disconnect the USB cable while
the computer and/or monitor are turned on.
Otherwise, a malfunction may result.
- Do not select 3D mode unless you display 3D
images.
- If you select 2D mode while displaying a 3D
image, the image may not display properly.
- For analog connection, adjust the screen
properly using the automatic screen adjustment,
etc.
- If the OSD Menu is hard to see in 3D mode,
select 2D mode to make adjustments.
- Also refer to [ReadmeE.txt] in the [3D], [SSD],
[English] folder in the supplied CD-ROM.
For software supporting SHARP 3D Technology
- The 3D display may be disabled when two or
more users are logged on. In this case, let all
users log off, and then log on as the user who
logged on first.
Viewing position
To see images in 3D mode, there should be
approximately 60 cm between you and the screen
and you should be positioned in front of the
screen. Straighten your back and direct both eyes
so that you are looking straight at the screen.
Guideline for proper viewing position
In 3D mode, a red strip is displayed at the bottom
of the screen. The best viewing position in 3D
mode is the position where the entire red strip (or
its bottom) appears darkest. Move your head
slightly up/down, right/left, and forward/backward
to adjust your position.
Note:
- With software that does not display a full screen,
the red strip may not display at the bottom of the
screen.

Displaying 3D images

Switching display between 2D and 3D mode
For software supporting SHARP 3D Technology
When you display a 3D image with 3D display-
ready software, the display mode is automatically
switched to 3D mode and the power LED color
changes to blue. When you display a 2D image,
the display mode returns to 2D mode and the
power LED color changes back to green.
If the display mode does not automatically switch
to 3D mode, press the 3D button to switch the
mode.
(When the 3D button is pressed again, the mode
returns to 2D mode.)
Notes:
- When 3D mode is selected by pressing the 3D
- After the 3D mode is activated by pressing the
For other software supporting 3D display
Confirm details by referring to the operation
manual of the software.
23
button, the mode may automatically return to 2D
mode after the monitor resumes from power-
saving mode.
3D button, if the monitor is turned off once and
turned on again, the mode returns to 2D mode.