Clearances Around Fireplace - Napoleon Ascent X Serie Manuel Du Propriétaire

Masquer les pouces Voir aussi pour Ascent X Serie:

Manuel du propriétaire (60 pages)

Les langues disponibles

Flush installation without mantel

Enclosure

Top of

ﬁnishing

ﬂange

(ﬁreplace

Appliance

opening)

Recessed installation with protrusion

Enclosure

Appliance

note:

•

These are recommended minimum clearances only and are in supplied in good faith and not a guarantee

of compliance with TV manufacturers' maximum allowable operating temperatures. Always comply to TV

manufacturers' requirements.

TV temperatures must be validated at the time of installation as air flow characteristics within the

•

room can vary and maximum acceptable operating temperatures can vary from appliance to appliance.

TVs cannot be used where the TV temperature exceeds the manufacturer's maximum allowable operating

temperatures (see TV manufacturer's specifications).

•

Mantel height and depth must conform to mantel clearance requirements specified in this manual, see

"minimum clearance to combustible mantel" section in installation manual.

•

Dimension "A" the gap between the top of the finishing flange and the bottom of the TV are taken from the

top of the appliance opening.

•

TV temperatures may be further reduced by increasing the horizontal distance between the front of the TV

and the front edge of the mantel or by increasing dimension "A". However, increasing the gap between the

top of the mantel and the bottom of the TV beyond the maximum recommended figure, typically results in

higher temperatures. Minimum clearance between the mantel and bottom of the TV should be maintained to

allow air circulation below and behind the TV.

TV bracket

6" min.

TV bracket

2.5" min.

2" min. (3" max. recommended)

Top of ﬁnishing ﬂange

(ﬁreplace opening)

See "minimum clearance

to mantle" section

(installation manual).