operating your appliance
EN
2.2.3 changing the batteries in the remote / battery holder (including switch)
WARNING
!
•
Ensure the gas and electrical power to the appliance is turned off.
•
Appliance may be hot, do not service until the appliance has cooled.
Battery holder (including
switch) would have been
located close to the
appliance during installation
For battery holder (including switch):
Remove the two screws securing cover plate to battery holder (including switch). Do not discard.
A.
Remove the 4 "AA" alkaline batteries in the battery holder (including switch) and replace with new ones.
B.
Note the polarity of the batteries and insert as indicated on the cover (+/-).
Secure the cover plate to the battery holder (including switch) using the screws removed in step A.
C.
For remote control:
Press the securing clip on the back of the remote control to release the back cover. Remove the 3 "AAA"
A.
alkaline batteries in the remote and replace with new batteries then press the ON button. The battery
holder will beep 4 times to indicate that the remote's command is accepted.
Battery Holder
(including switch)
Slider Switch
Reset / Program
Button (PRG)
10
W415-1853 / B / 10.18.18
(Illustrated with cover
plate removed)
Remote control