Bowers & Wilkins P5 Wireless Mode D'emploi page 6

9. P5 Wireless wired connection
In addition to operating wirelessly, your P5 Wireless
can be connected to a music source using the
supplied universal cable. Cable connection is useful
if the battery is low or if P5 Wireless is to be used
with a non-Bluetooth audio source device.
To connect the supplied cable to your P5 Wireless
proceed as described in the following steps and
illustrated in Diagram 5.
Carefully pull the left ear pad away from the body of
the ear piece. The ear pad is held magnetically and
will detach with little effort.
Take one end of the connection cable and carefully
insert it into the socket beneath the ear pad. Dress
the cable as illustrated in Diagram 5.
Replace the ear pad.
The universal cable must be disconnected for P5
Wireless to switch on and connect via Bluetooth,
however its battery can be charged while the
universal cable is connected.
Note: Connecting the universal cable will
automatically switch off the Bluetooth and
powered elements of P5 Wireless. P5 Wireless
will not however switch on automatically when
the universal cable is disconnected.
10. Reboot
To perform a reboot use a straightened paper-clip to
press and hold the Reboot button for two seconds
as illustrated in Diagram 6. The headphones will turn
off, press Power on and reboot will be complete.
Note: performing a reboot will not clear the
paired device memory.
11. Cleaning your P5 Wireless
Clean your P5 Wireless by using a damp cloth and
dabbing the leather until clean, do not rub the cloth
on the leather. Do not use cleaning detergents or
leather polish, doing so may cause damage to the
product.
Diagram 5
Attaching the audio cable
Diagram 6
Reboot
6