Care And Use; Property Damage - Emerson InSinkErator F-HC1100 Manuel Du Propriétaire

Masquer les pouces Voir aussi pour InSinkErator F-HC1100:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IN-HOME FULL SERVICE LIMITED WARRANTY
Dispenser:
5-year warranty
Stainless Steel Tank:
3-year warranty
Filtration System:
1-year warranty (excluding replaceable filtration cartridge)
This warranty is provided by InSinkErator, a business unit of Emerson Electric Co., ("InSinkErator" or "Manufacturer" or "we" or
"our" or "us") to the original consumer owner of the InSinkErator product with which this warranty is provided (the "InSinkErator
Product"), and any subsequent owner of the residence in which the Product was originally installed ("Customer" or "you" or "your").
InSinkErator warrants to Customer that your InSinkErator Product will be free from defects in materials and workmanship, subject
to the exclusions described below, for the "Warranty Period", commencing on the later of: (a) the date your InSinkErator Product is
originally installed, (b) the date of purchase, or (c) the date of manufacture as identified by your InSinkErator Product serial number.
You will be required to show written documentation supporting (a) or (b). If you are unable to provide documentation supporting
either (a) or (b), the Warranty Period commencement date will be determined by Manufacturer, in its sole and absolute discretion,
based upon your InSinkErator Product serial number.
What is Covered
This warranty covers defects in materials or workmanship, subject to the exclusions below, in InSinkErator Products used by a consumer
Customer for residential use only, and includes all replacement parts and labor costs. YOUR SOLE AND EXCLUSIVE REMEDY
UNDER THIS LIMITED WARRANTY SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE INSINKERATOR PRODUCT.
What is not Covered
This limited warranty does not extend to and expressly excludes:
• Losses or damages or the inability to operate your InSinkErator Product resulting from conditions beyond the Manufacturer's
control including, without limitation, accident, alteration, misuse, abuse, neglect, negligence (other than Manufacturer's),
failure to install, maintain, assemble, or mount the InSinkErator Product in accordance with Manufacturer's instructions or
local electrical and plumbing codes.
• Wear and tear expected to occur during the normal course of use, including without limitation, cosmetic rust, scratches, dents
or comparable and reasonably expected losses or damages.
In addition to the above exclusions, this warranty does not apply to InSinkErator Products installed in a commercial or
industrial application.
No Other Express Warranty Applies
This warranty is the sole and exclusive warranty provided to the Customer identified above. No other express warranty, written or
verbal, applies. No employee, agent, dealer, or other person is authorized to alter this limited warranty or make any other warranty on
behalf of Manufacturer. The terms of this warranty shall not be modified by the Manufacturer, the original owner, or their respective
successors or assigns.
What we will do to Correct Problems
If your InSinkErator Product does not operate in accordance with the documentation provided to you, or you have questions
concerning your InSinkErator Product or how to determine when service is needed, please call the toll free InSinkErator AnswerLine
at 1 (800) 558-5700, or visit our website at www.insinkerator.com. You may also notify us at: InSinkErator Service Center, 4700 21st
Street, Racine, Wisconsin 53406 USA.
The following information must be provided as part of your warranty claim: your name, address, phone number, your InSinkErator
Product model and serial number, and if necessary, upon request, written confirmation of either: (a) the date shown on your
installation receipt, or (b) the date shown on your purchase receipt.
Manufacturer or its authorized service representative will determine, in its sole and absolute discretion, if your InSinkErator Product
is covered under this warranty. You will be given the contact information for your closest authorized InSinkErator Service Center.
Please contact your InSinkErator Service Center directly to receive in home warranty repair or replacement service. Only an
authorized InSinkErator service representative may provide warranty service. InSinkErator is not responsible for warranty claims
arising from work performed on your InSinkErator Product by anyone other than an authorized InSinkErator service representative.
If a covered claim is made during the Warranty Period, Manufacturer will, through its authorized service representative, either repair
or replace your InSinkErator Product. Cost of replacement parts or a new InSinkErator Product, and cost of labor for repair or
installation of the replacement InSinkErator Product are provided at no cost to you. Repair or replacement shall be determined by
Manufacturer or its authorized service representative in their sole discretion. All repair and replacement services will be provided to
you at your home. If Manufacturer determines that your InSinkErator Product must be replaced rather than repaired, the warranty on
the replacement InSinkErator Product will be limited to the unexpired term remaining in the original Warranty Period.
Limitation of Liability
TO THE EXTENT PERMITTED BY LAW, IN NO EVENT SHALL MANUFACTURER OR ITS AUTHORIZED SERVICE
REPRESENTATIVES BE LIABLE FOR ANY INCIDENTAL, SPECIAL, INDIRECT, OR CONSEQUENTIAL DAMAGES, INCLUDING
ANY ECONOMIC LOSS, WHETHER RESULTING FROM NONPERFORMANCE, USE, MISUSE OR INABILITY TO USE THE
INSINKERATOR PRODUCT OR THE MANUFACTURER'S OR ITS AUTHORIZED SERVICE REPRESENTATIVE'S NEGLIGENCE.
MANUFACTURER SHALL NOT BE LIABLE FOR DAMAGES CAUSED BY DELAY IN PERFORMANCE AND IN NO EVENT,
REGARDLESS OF THE FORM OF THE CLAIM OR CAUSE OF ACTION (WHETHER BASED IN CONTRACT, INFRINGEMENT,
NEGLIGENCE, STRICT LIABILITY, OTHER SORT OR OTHERWISE), SHALL MANUFACTURER'S LIABILITY TO YOU EXCEED THE
PRICE PAID BY THE ORIGINAL OWNER FOR THE INSINKERATOR PRODUCT.
The term "consequential damages" shall include, but not be limited to, loss of anticipated profits, business interruption, loss of use or
revenue, cost of capital or loss or damage to property or equipment.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to
you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
14

CARE AND USE

Electric Shock Hazard: To prevent electrical shock, disconnect power before
servicing unit. Use only a properly grounded and polarized electric outlet.
ADJUSTING THE THERMOSTAT
Factory temperature pre-set is 200˚F.
approx. 200°
To reset the thermostat to 200°,
turn the indicator two notches to
the right of vertical.
Adjust the thermostat
slowly, turning the dial
clockwise to increase
temperature or counter
clockwise to decrease temperature, then
activate faucet handle for 20 seconds to
bring in fresh water to be heated at the new
setting. Allow 5-7 minutes for water to reach
new temperature.
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.
SEASONAL STORAGE/DRAINAGE
Anytime the instant hot water dispenser is not used for
extended periods of time, unplug and drain unit. If it is below
freezing you will need to unplug the unit and drain it.
Disconnect power from unit (unplug unit).
Push hot water dispenser faucet lever and
allow water to flow until it is cool.
Shut the cold water supply off at the valve.
Disconnect tubes from the tank.
Unhook tank from wall.
Hold tank upside down and drain the water
into the sink.
Towel dry any water drippings from tank area.
Reinstall tank to wall and reconnect tubes.
Remove and discard filter cartridge,
if applicable.
To put back into working order, install new
filter cartridge (if applicable) and turn on cold
water supply at valve. Depress the hot water
dispenser faucet lever and hold until water
flows from the spout. Reconnect the
electrical cord. (Refer to Page 11, Step 6B)

PROPERTY DAMAGE

Regularly inspect the unit for any signs of
leakage. If there are signs of water damage,
immediately remove the unit from service.
To avoid water damage from leakage,
replace all cut, loose or split tubing.
A drain pan, plumbed to an appropriate
drain or outfitted with a leak detector,
should be used in those applications where
any leakage could cause
property damage.
FILTER GUIDE AND REPLACEMENT
Replace filter cartridge when there is an obvious decrease
in water flow to the faucet or if there is an objectionable
taste or odor to the water.
When the inlet and outlet ports have been closed and
the filter's internal pressure has been relieved, water
(about 2 oz) will discharge from vent line.
If the new filter cartridge cannot be inserted, insert the
old one and turn until it stops, remove it and then retry
the new cartridge.
Carbon filters should be replaced within 6 months.
Filter replacement instructions:
Replace with an InSinkErator
filter.
®
Place pan or dish towel under the filter to
catch water drainage during change.
Slowly turn the cartridge counter-clockwise
completely until it stops (1/4 turn).
Pull cartridge straight down and discard.
Insert new cartridge into filter head.
Top surface of cartridge will become flush
with the bottom of the filter head when
fully engaged.
Turn the cartridge clockwise until it stops
(1/4 turn).
Align the in/out arrow on the head and
bracket assembly to the in/out arrow on
the cartridge.
Open faucet to expel trapped air.
For the F-1000S and F-1000, flush
2.25 gallons through filter before use
(approximately 3 minutes). For the F-2000S
and F-2000, flush 3 gallons through filter
before use (approximately 4 minutes).
CLEANING THE FAUCET AND TANK
Only use mild cleaners to clean the faucet
and plastic components.
Cleaners with acids, abrasives, alkaline or
organic solvents will result in deterioration of
the plastic components and void the warranty.
PERSONAL INJURY
Regularly check for signs of corrosion
by examining the appearance of the
dispensed water.
If there is any discoloration or rusty appearance,
unplug and drain unit as described in the
Seasonal Storage/Drainage section on this
page of the manual.
If the water discoloration remains after
draining and refilling unit, discontinue use
and contact an authorized InSinkErator
service agent.
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Insinkerator f-gn1100Insinkerator f-hc2200Insinkerator f-gn2200Insinkerator f-hc2215Insinkerator f-gn2215Insinkerator f-hc3300 ... Afficher tout

Table des Matières