SportDOG TEK 1.0 Add-A-Dog Manuel D'utilisation page 3

TO ADD THE E-COLLAR MODULE TO YOUR GPS COLLAR:
1. Slide the bottom plate cover off the GPS Collar.
2. Slide the antenna on the E-Collar Module into the antenna keeper on the GPS Collar. Then, slide the
E-Collar Module onto the GPS Collar, placing the screws included in your TEK-T Add-A-Dog™ on
each side of the contact points.
3. Using the Allen screwdriver that came with your TEK-T Add-A-Dog™, turn the screws clockwise to
tighten them.
4. If you ever have the need to remove the E-Collar Module, reverse this procedure. Be sure to store
the screws in a safe location so that you can re-attach the E-Collar Module in the future.
TO SET TRACK & TRAIN MODE:
Once the E-Collar Module has been added to the GPS Collar, the Handheld Device must be configured to
operate in TRACK & TRAIN mode. In this mode, the Handheld Device will track the location of dogs and
all stimulation functions will be enabled.
1. From the main menu, select SETTINGS > GENERAL.
2. Press the right arrow to select TRACK & TRAIN.
Refer to the TEK SERIES Operating Guide provided on the disc for instructions on how to pair collars to
the Handheld Device and how to enable the E-Collar Module to deliver stimulation, vibration, and/or a
tone for correcting your dog.
WWW.SPORTDOG.COM
3