Guardian MDS86800XWS Mode D'emploi Et Garantie page 5

ASSEMBLY INSTRUCTIONS
1. Carefully remove the rollator components from the shipping carton.
Refer to diagram (Figure 1) as needed.
2. Examine all parts for shipping damage. DO NOT use the rollator if
there is apparent damage or if any parts (other than the basket) are
missing. If there are missing or damaged parts, please call Medline
Customer Care toll free at 1-800-MEDLINE.
3. Lay the rollator down so that the seat is facing the floor. Cut the
plastic ties from the rear wheels and unfold the legs. Straighten the
legs until the rollator unfolds.
4. Flip the rollator over so that the seat faces up. Insert front wheel (G)
into frame. Insert Round Hand Screw (J) into frame.
5. Unfold the rollator by pushing down on the support rod (F) to spread
apart the frame until the folding brackets (I) are in full extension.
Push the seat down into place.
6. Insert the handlebars (B) so that the handgrips (A) are aligned with
the rear wheels. The brake cables should be on the outside of the
handlebars and frame. Ensure excess brake cable loops out the front
of the rollator.
7. Adjust the height of the handlebars (B) for proper fit. To determine
proper height, stand upright behind the rollator with shoulders
relaxed, arms hanging at your side and eyes looking straight ahead.
Standing in this position, the handgrips (A) of the rollator should be
adjusted to a height even with the wrists. This will position the arms
at an approximate 20º to 30º bend when using the rollator. Secure
the handlebars at the closest hold to the desired height. Insert and
tighten the triangular hand screws until secure. See Figure 2.
(Important: Hand Tighten Only!)
8. Insert the padded backrest (C) so that the padded portion faces
the front of the unit. Push down on the buttons on the side of the
backrest until the spring pins lock into place.
9. Place the basket under the seat.
MDS86800XWS(PIC-00311)
Revised: 10/13/2017
4