Accessories Installation - AERMEC Novatherm TRS251 Manuel D'installation Et Mise En Service

EN

ACCESSORIES INSTALLATION

BEFORE UNDERTAKING WHICHEVER INSTALLATION OPERATION MAKE SURE THAT THE MACHINE IS SWITCH OFF AND
THAT IT CAN NOT BE ACCIDENTALLY CONNECTED TO THE POWER. IT IS THEREFORE NECESSARY TO CUT OFF THE ELEC-
TRIC SUPPLY DURING ALL MAINTENANCE.
Touch screen controller - TRSPTS
The panel is supplied with a 5 meter long cable and connectors for connection to the electronic board on the machine. If
necessary, a longer cable can be used to load the installer
VW-1 80°C 300V). See dedicated chapter for details of the connection to the electronic board. The device can be fixed to the
wall using the plastic jig supplied: see the figure below.
WARNING - To avoid malfunction of the unit:
- Do not install the panel near other electronic devices (Eg: Wi-Fi Router);
- Do not pass the power cable through conduits with other electric cables.
CO wall mount sensor - TRSQSW
2
The CO sensor comes complete with a 5 metre long cable and connectors for connection to the electronic board on the machine. If
2
necessary, a longer cable can be used to load the installer
80°C 300V). See dedicated chapter for details of the connection to the electronic card.
The device should be installed in the room where live most of people; it can be fixed to the wall using the mask provided: see the
figure below.
Humidity sensor - TRSUSW
The humidity sensor comes complete with a 5 metre long cable and connectors for connection to the electronic board on the ma-
chine. If necessary, a longer cable can be used to load the installer
VW-1 80°C 300V). See dedicated chapter For details of the connection to the electronic card.
49
(max. 15 metres overall, cable specification AWM 2464 24AWG
(max. 15 metres overall, cable specification AWM 2464 24AWG VW-1
(max. 15 metres overall, cable specification AWM 2464 24AWG