Checks Before Shipment; Transport; Unloading; Installation And Start Up - AERMEC Novatherm TRS251 Manuel D'installation Et Mise En Service

CHECKS BEFORE SHIPMENT

All the units, before being sent, undergo a series of checks, as listed below.
• Visual inspection of the finishes
• Checks to ensure all the components are integral
• Electrical safety checks
• Functional test on the electric fans
• Application of the identification plates.

TRANSPORT

• The air handling units are packed in cardboard boxes that must remain intact until assembly.
• The components that, due to technical, constructional, transport or other requirements are not fitted on the unit, but sent
separately either inside the unit or otherwise, are specially protected and duly described on the packing list.
• No other material must be stacked on the products: the manufacturer declines all liability in the event of damage deriving
from such loads.
THE FASTENING OF THE LOAD ON THE TRUCK IS THE RESPONSIBILITY OF THE CARRIER, AND MUST BE PERFORMED, US-
ING STRAPS OR ROPES, SO AS TO AVOID DAMAGING THE PACKAGING

UNLOADING

Checks upon receipt
When receiving the goods, before unloading, all the material delivered must be checked to ascertain the presence of any dam-
age caused during transport. Any damage found must be reported to the carrier, accepting the goods with reservation and
specifying the type of damage on the delivery documents.
Hoisting and handling
It is strongly recommended :
WHEN HANDLING THE UNITS, USE SUITABLE MEANS ACCORDING THE WEIGHTS INVOLVED, AS ENVISAGED BY EC DIREC-
TIVE 89/391 AND SUBSEQUENT AMENDMENTS
• The weight of the units is shown on this manual
• Avoid uncontrolled rotations
• Place the goods down with care, avoiding sudden movements or, worse, dropping the goods.
Storage
In the event of extended storage before installation, keep the units protected from dust and bad weather and away from
sources of vibrations and heat.
THE MANUFACTURER DECLINES ALL LIABILITY FOR DAMAGE DERIVING FROM INCORRECT UNLOADING OR INAD-
EQUATE PROTECTION OF THE UNITS AGAINST THE ELEMENTS.

INSTALLATION AND START UP

Definitions
CUSTOMER - The customer is the person, the agency or the company who bought or rented the unit
USER / OPERATOR - The operator or user is the physical person who uses the unit for the purpose for which it was designed
SPECIALISTIC STAFF - It is composed by the physical trained persons, able to recognize any danger due to the proper and
improper use of the unit and able to avoid or repair it. inflammable or toxic gases at a high temperature.

SAFETY STANDARDS

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR THE FAILURE TO COMPLY WITH THE SAFETY AND ACCIDENT
PRE-VENTION STANDARDS DESCRIBED BELOW. IT ALSO DECLINES ALL LIABILITY FOR DAMAGE CAUSED BY IMPROP-
ER USE OF THE UNIT AND/OR MODIFICATIONS PERFOR-MED WITHOUT AUTHORISATION.
SPECIALISED STAFF MUST PERFORM INSTALLATION.
• Wear suitable and accident-prevention clothing during installation, for example: goggles, gloves etc. as indicated in the cu
rent regulation
• During installation operate in complete safety, clean environment and free from obstructions.
• Respect the laws in force, in the country in which the machine is instal.
led, relative to use and disposal of packaging and the products used for cleaning and maintenance of the machine, as well as
complying with that recommended by the producer of these products.
• Do not touch moving parts or intervene between these.
EN
34