AERMEC Novatherm TRS251 Manuel D'installation Et Mise En Service page 38

ELECTRICAL CONNECTION
Warning
Power must be isolated during installation and before maintenance to avoid injury by electric shock. The specifications of
cables must strictly match the requirements, otherwise it may cause performance failure and danger of electric shock or
fire.
Power supply is AC 230V / 50 - 60 HZ 1 Phase and ground. Open the cover of electrical box, connect the 3 wires (L/N/PE) to
the terminals and connect the cable of the control panel to the board according to the wiring diagram, and join the control
panel to the cable. A cable fixing device offered by installer is recommended to fix the power cable on the wall/ventilator.
Model
TRS251
TRS351
TRS501
TRS651
TRS801
TRS1001
TRS1301
Warning
We do not accept any liability for any problems caused by the user's self and non-authorized reengineer to the electrical
and control systems.
Spec. of power supply cable
2 x 1.5 mm²
EN
Spec. of safety and controller cable
2 x 0.5 mm²
38